hr@vistrainspection.com+91 XXXXX XXXXXMon–Sat 9:00–18:30 · 24×7 shutdown support
Registration FREE for freelancers, clients & collaborators
Vistra Inspection Services and Consultants

Stage-wise & In-process Inspection

Inspection at every hold and witness point of your QAP – fit-up, welding, NDT, machining and assembly.

Defects caught at fit-up cost a fraction of defects found at the hydrotest or at the customer's site. Stage-wise inspection puts an independent inspector at each critical stage of manufacturing, so that problems are corrected before they are buried under the next weld pass, coating or assembly.

Vistra prepares or adopts your QAP, agrees the hold and witness points with your buyer and attends each stage at short notice through our network of local inspectors in every industrial area of India.

Scope of stage-wise & in-process inspection

  • Material receipt inspection and identification
  • Marking, cutting and edge preparation checks
  • Fit-up, root gap, alignment and tack-weld inspection
  • Welding parameter monitoring against the WPS
  • Back-gouging, intermediate NDT and final weld visual
  • Post weld heat treatment (PWHT) chart review
  • Machining, bore and flange face inspection
  • Assembly, alignment and run-out checks

Codes & standards we work to

Approved QAP / ITPASME Sec VIII & IXIS 2825EN ISO 5817Client drawings and tolerances

What you receive

Stage-wise inspection report
Photographs of every stage
Hold point release
Weekly progress summary for buyers

Industries we serve

Popular packages

Inspection
Fabrication & Heavy Engineering

Fabrication TPI – Stage Inspection Visit

Independent stage inspection of fit-up, welding and dimensions at your fabrication shop.

₹6,500 per man-day
Inspection
Pressure Vessel Manufacturers

Hydrotest Witness – Pressure Vessel

Witness of hydrostatic test with gauge calibration check and certificate.

₹6,500 per visit
Inspection
Steel Structures, PEB & Bridges

Structural Steel & PEB Inspection

Material, welding, UT, galvanising and DFT inspection of structural steel.

₹6,000 per man-day

Available across India

We provide stage-wise & in-process inspection in every state and district of India. Popular locations:

Frequently asked questions

Where do you provide stage-wise & in-process inspection?

We provide stage-wise & in-process inspection in all 36 states and union territories of India, through inspectors based in the major industrial hubs and a network of registered freelance inspectors.

How much does stage-wise & in-process inspection cost?

Most visits are charged per man-day; NDT can also be charged per shift, per exposure or per point. See the Requirements Shop for indicative rates, or ask for a firm quote.

How fast will I get the report?

A photo-backed inspection report is normally issued within 24 hours of the visit, with the inspection release note after acceptance.

Need an inspector, NDT technician or QA/QC consultant?

Tell us the product, code, location and dates – we respond within one working day.

All 36 States & UTs780 districts covered
Qualified inspectorsASNT / ISO 9712 Level II & III
Reports in 24 hoursPhoto-backed, code-referenced
Secure paymentsUPI · Cards · Net banking
Install the Vistra appFaster access to inspectors & requirements